Operation Manual

MI 3309 BT DeltaGT Autotest sequences
61
There are no special options in the RCD result screen.
6.1.1.12 Functional test
Figure 6.21: VDE Organizer – Functional test result screens
Options in Functional test result screen:
PASS / FAIL
To be applied manually.
Option if General or Appliance with heating elements is set:
POWER
Starts Power test. The measurement is described in chapter 5.2.11
Power test.
Option if IEC leads, multiple outlets without electronic parts is set:
POLARITY
Starts Polarity test. The measurement is described in chapter 5.2.7
Polarity test
Note:
 After Power or Polarity test is completed, ESC key should be pressed to return to
Functional test result screen.
6.2 Custom autotest
In the autotest custom menu user-defined autotest procedures can be performed via the
PC SW PATLink PRO. Up to 50 custom autotest sequences can be pre-programmed in
this autotest mode.
Commonly used pre-programmed autotest sequences are added to the list by default.
The custom sequences can be also uploaded from the PC via PC SW PATLink PRO.
Refer to chapter 8 Communication for more information.
New custom sequences can be also uploaded from the VDE Organizer.
Refer to chapter 7 Working with autotest results for more information.
The pre-programmed sequences can be restored to default sequences by selecting Initial
settings in Setup menu.
Select Custom Autotest function in Main menu.
Figure 6.22: Custom autotest menu
Keys:
 / 
Selects the custom autotest.
START
Starts the selected custom autotest. See chapter 6.5 Carrying out
autotest sequences (Code, Simple and Custom).
ESC
Returns to Main menu.