Operation Manual

MI 2092 Power Harmonics Analyser Section I General information
15
There may exist special environmental regulations concerning the disposal of
batteries. These must be followed.
In case of blown battery fuse (F1), this should be replaced with the same type
as defined on the label close to it.
3.8.2. Cleaning
To clean the surface of instrument, use a soft cloth slightly moistened with soapy water
or alcohol. Then leave the instrument to dry totally before use.
· Do not use liquids based on petrol or hydrocarbons!
· Do not spill cleaning liquid over the instrument!
3.8.3. Periodic calibration
To ensure correct measurement, it is essential that the Instrument be regularly
calibrated. If used continuously on a daily basis, a six monthly calibration period is
recommended, otherwise annual calibration is sufficient.
3.8.4. Service
For repairs under warranty, or at any other time, please contact your distributor.
Manufacturer’s address:
METREL d.d.
Ljubljanska 77
1354 Horjul
Slovenia
Tel: +(386) 1 75 58 200
Fax: +(386) 1 75 49 095
E-mail [e-mail]
The Instrument contains no user serviceable parts.
Service or calibration must only be carried out only by
an authorized dealer!