Operation Manual

MI 2092 Power Harmonics Analyser Section V PC software
36
Section V PC software
The Power Harmonic Analyser is supplied complete with a powerful suite of Windows
software that can be used for:
· Configuring the Instrument
· Setting measurement parameters
· Download of recorded data
· Off-line analysis of recorded data
· On-line capture and analysis of current voltage and power signals.
The software also provides the necessary tools to allow measured data etc to be
included in various reports.
The Minimum requirement for running the software is the ability of the PC to run
Windows 98
DIRECT LINK
SCOPE
SELECT RECORDING FOR ANALYSIS
EDIT INSTRUMENT SETTINGS
DOWNLOAD DATA FROM INSTRUMENT
REMOTE
STOP
OPEN
FILE
REMOTE
START
REMOTE
CLEAR MEM
EXIT
HELP
CHANGE
LANGUAGE
PRINTER
SETTINGS
PORT
SETTINGS
HANG UP
COMMUNIC.
MAKE MODEM
COMMUNIC.
fig. 24: Basic opening screen
The Basic opening screen is the starting point for all actions. It provides general
information about the Instrument and - by clicking on 'toolbar buttons' or selecting pull-
down menus - access to all functions. The buttons provide access to:
· Download of data
· Setting Instrument configuration parameters
· Analysis of downloaded or previously saved data
· Direct Link - Operating on-line with the Instrument
· Data Logging START/STOP
To set the instrument configuration parameters, double click on Settings; the
programme will download current settings from the instrument and display them on the
screen.