Operation Manual

MI 2092 Power Harmonics Analyser Section VII Modem data transfer
63
5. Connecting and disconnecting modems
When the modems are connected and suitably set at the instrument and the PC, just
click the “Make modem connection” button in Power Link toolbar or select “Make
modem connection” in Modem menu. It takes a few seconds (up to 30 s) to establish
communication link. The instrument operates as it is connected directly to the PC via
RS232 interface. It means that all interface functions are active, e.g.: receive / transmit
instrument settings, data download, manipulating of the recording function, clear
memory.
To disconnect just click on “Hang-up modem connection“ button on Power Link
toolbar or select “Hang-up modem connection” in Modem menu.
6. SMS messages
The instrument has possibility to send an SMS message to the mobile phone when
GSM modem communication is enabled. Messages are intended to inform the operator
about some events regarding the instrument.
The following events can be sent as SMS messages:
- Less than 50% of recording memory is free.
- Less than 20% of recording memory is free.
- Recording memory is full.
- WAVEFORM, FAST LOGGING, TRANSIENT, EN50160 or PERIODICS recording is
finished.
For SMS messaging prepare the following configuration:
ENABLE PASSW.
GSM/SMS PARAM. => ENABLED >> DISABLE
DATE/TIME CPIN :
LANGUAGE DEST: XXXXXXXXXXXX
SYSTEM REINIT. USERID: XXXXXXXXXX
CLR.REC.MEM. SEND TEST MESSAGE
- Enter Destination phone number “DEST:” (phone number of the mobile phone that
will receive SMS messages from the instrument) using cursor keys.
- Enter user ID “USER ID”: (optional instrument identification string) using cursor
keys as described in chapter 3.4.
- Provide PIN card of modem terminal with the number of your local.
- It can be done with “SEND TEST MESSAGE” command in GSM/SMS
PARAMETERS menu of the instrument.
Press Enter to confirm settings or ESC to discard them.
Note:
- SMS message cannot be sent if modem communication is established.
- If you do not want the instrument to send SMS, disable GSM/SMS PARAM. and set
baud rate to 9600.