Operation Manual

OmegaGTPlus / BetaGTPlus Main menu and test modes

3.1.3 Performing autotest sequences

Once the any of autotest sequence is selected it can be performed.

Keys:

START

Starts of selected autosequence execution.

ESC

Returns back main menu.

Main principle is that after each successfully finished procedure in the autosequence,

the next procedure is automatically prepared for execution and waits for operator to

prepare new test setup (optional) and start the test.

Notes:

Ì Only visual test waits the operator to press the proper keys.

Ì Pay attention on correct wiring when preparing test setup. Press Help to see

suggested test setup.

Ì Consider the displayed warnings before starting measurement!

Ì Attached display figures are mainly selected for VDE Organizer. They are valid

also for any other autotest sequence.

Ì Disabled tests are excluded from decision of proper condition for further tests in

autotest sequence.

Visual inspection function

During visual inspection the following items should be checked for damages:

Ì Appliance plug,

Ì Appliance enclosure,

Ì Appliance mains cord.

Visual test menu

Keys:

F1 (PASSall)

All observed items are proper without any damages.

F2 (PASS)

Currently selected observed item is in order.

F3 (FAIL)

Currently selected observed item is damaged.

F4 (SKIP)

Skip inspection to the next test function.

F5 (END)

Finish currently performing autotest.

ESC

Returns back autotest entry menu.