Operation Manual

OmegaGTPlus / BetaGTPlus Main menu and test modes
28
Save option Save as option
Autotest custom save menus
Keys:
½ / ¾
Select character in line.
Alphanumeric Enters character.
SHIFT+ Alphanumeric Enters small letter or special character.
Å
Deletes character left to cursor.
F1 (SAVE)
Confirms saving custom autotest sequence under
entered name.
F2 (UNDO)
Cancels saving.
ESC
Returns back to custom autotest menu.
Note:
 Exit without saving will lose all modified settings of selected autosequence
immediately after returning to Custom autotest menu.
 If you want to save more than 50 autotests, the »Out of memory« message is
displayed.
3.3 Project autotest menu
The first step when performing a Project Autotest is to recall stored appliance data from
the instruments memory. The procedure is similar as if test results are to be recalled
from the instrument’s memory.
The Project Autotest search menu is a tool that simplifies and speeds up repeated
(periodic) testing of appliances. The main idea is to re-use known and stored data about
the tested appliance.
Hints
Test sequence
If the sequence is not changed (usually the sequences are not
changing for the same appliance) the user does not need to care
about setting the right test sequence and parameters.
Appliance data
ID number, names, descriptions, addresses, comments are not
needed to be re-entered again. Old data are offered by default
Old test results
Actual Project Autotest test results can be compared with the
previous ones. The instrument automatically calculates the trends
for each measurement.
Old test results can be uploaded from PC back to the instrument. This brings further
advantages: