Operation Manual

MI 3310 / MI 3310A SigmaGT Autotest sequences

 When active polarity test is enabled in autotest sequence then mains supply voltage

is applied on test socket during earth bond test (if selected in autotest sequence).

6.2.1 Viewing, modifying and saving an custom autotest

An existing custom autotest sequence can be viewed, modified and saved. These

functionalities are available in the Custom autotest view menu.

View setup of selected custom autotest

Keys in custom autotest sequence view mode:

 / 

Select test function in the sequence.

SAVE (F2) Stores autotest sequence under the same name. See chapter

6.2.1.2 Saving autotest sequences.

SAVE AS (F3) Stores autotest sequence under a new name. See chapter 6.2.1.2

Saving autotest sequences.

EDIT (F4) Opens menu for modifying parameters of selected test function. See

chapter 6.2.1.1 Modification of an autotest sequence.

START

Starts running the selected autotest. See chapters 6.5 Performing

autotest sequences - appliances or 6.6 Performing autotest

sequences – welding machines.

BACK (F1)

Returns back to custom autotest menu.

ESC

6.2.1.1 Modification of an autotest sequence

Each test function has at least one parameter to set / reset or adjust.

Common parameters:

MODE

Defines appearance of selected function, see table below.

If MODE not disabled

OUTPUT

Amplitude of measuring quantity, see particular test functions.

LIMIT

Limit value of measured item, intended for PASS/FAIL decision.

TIME

Required test period.

Measurement mode options:

Mode Option Note

Disable

The selected measurement is skipped.

Single

One measurement will be performed