Operation Manual

MI 3310 / MI 3310A SigmaGT Autotest sequences
102
Continuity autotest menu
Keys:
START
Starts the continuity measurement.
Proceeds with the next continuity measurement (in continuous
mode).
Proceeds to the next autotest sequence measurement (in single
measurement mode only).
ENTER
Proceeds to the next autotest sequence measurement (in continuous
measurement mode only).
REPEAT (F3) Repeats the continuity measurement.
SKIP (F4) Skips the continuity measurement.
HELP
Displays the continuity help screen.
ESC
Ends the autotest sequence.
Note:
 Compensation of test leads resistance should be performed before doing autotests.
6.6.3 Insulation resistance (supply circuit to protective circuit)
Measurement is described in chapter 5.3.2 Insulation resistance (supply circuit to
protective circuit). If this insulation test fails or was skipped other tests will not be carried
out because of safety.
Insulation LN - PE autotest menu
Keys:
START
Starts the insulation resistance measurement.
Proceeds with the next insulation resistance measurement
(in continuous mode).
Proceeds to the next autotest sequence measurement (in single