Operation Manual

MI 3310 / MI 3310A SigmaGT Main menu and test modes

Keys:

 / 

Modifies highlighted parameter.

SAVE (F1) Saves setting of selected item,

UNDO (F2) Recovers currently modified setting.

ESC

Returns to main settings menu.

Notes:

 If blank is selected for a particular item, then the appropriate field will initially appear

blank in the Save results menu.

 If replicate option is selected for a particular item, the last entered data will initially

appear in an appropriate field when new autotest sequence is finished.

 The increment option can also be set in the device number field. In this case, the

DUT number will be automatically incremented when new autotest sequence is

finished.

 Special character »$« between autotest shortcut code and DUT name (ID number)

is used to distinguish shortcut code from DUT name.

 Only DUT ID is printed out on the 2

DUT label (power supply cord label).

 Refer to Appendix B for more information about barcode systems.

4.2.8.7 Reset instrument settings

In this menu the following parameters can be set to their initial values:

- All measurement parameters in single test mode,

- User defined tests are cleared,

- Custom autotest sequences are replaced by factory pre-programmed ones,

- PC baud rate is set to 115200 bps,

- Printer protocol is set to hardware handshaking – flow control (DTR).

The following menu is displayed:

Original settings menu

Keys in instrument settings menu:

Confirms reset to default values and returns to Setup menu.

Returns to Setup menu without reset.