User Manual

3. LIO-8 Quick Start Guide

Figure 3.1: LIO-8

Prepare the unit for use

Unpack the LIO-8 and make sure all the parts are there:

• One LIO-8 unit

• One IEC Power Cord appropriate for your area

• One 24-volt 48-watt world-ready external power supply

• One 30” IEEE 1394 9-pin to 6-pin FireWire Cable

• One 4.5 meter IEEE 1394 9-pin to 6-pin FireWire Cable

• Two Rack Ears w/ fasteners

• Rubber feet

• Configuration jumpers

• MIO Software CD-ROM

• Warranty/Registration Card

Bask in the look and feel of the LIO-8! Once you’re finished, connect the power supply. Now connect your

input and output cables along with your monitors and signal sources. Your monitors should be connected to

Analog Out 1/2, either via a DB25 cable or the 1/4" TRS jacks. Turn the unit on using the front panel switch.

Cool, isn’t it?