Operating instructions

10 10/04/2015
Electronic mobile POCLAIN HYDRAULICS
Fitting the controller
The controller must be fixed on a rigid support. Make sure that there is enough space to fit the connector (min. 65 mm [min. 2.56 in]).
The controller shall be preferably mounted in vertical position (connectors at the bottom) to enhance ventilation and avoid dust accumulation on
cooling fins.
The controller's housing has to be connected to the ground (chassis) of the vehicle and to be installed on a flat surface (flatness of 0,5/
100x100mm [3.94x3.94 in]).
Electrical connections Commercial name Part number
SmartDrive™ CT main connector
KIT-CONNECT-SD-CT-200
A48149L
page 64
KIT-CONNECT-SD-CT-300
A48140B
SmartDrive™ CT communication
connector
KIT-CONNECT-COM-M-SD-CT
A48693C page 66
Connector kit 120:
KIT-PLUG-120-DTM-2S
A52539H page 68
SmartDrive™ CT-200 cable
CABLE-SD-CT-200-60-5000
A48878D page 89
SmartDrive™ CT-300 cable
CABLE-SD-CT-300-86-5000
A48877C page 85
Screw (X4): M6
Nut (x4): M6
Shim (x4) : M6
Tightening torque: 6 Nm
Top
Bottom