User's Guide
Table Of Contents
- Remote Terminal Unit M717
- Table Of Contents
- Introduction
- Installation
- Register the RTU to the M2M Gateway
- The SDI Connector
- The MPI Connector
- The Micro USB Service Connector
- About the Data Acquisition Subsystem
- SDI-12 Sensors
- Create a New Template From an Existing One
- Create a New Template From Scratch
- Interface to a Davis Vantage Pro Console
- Interface to a Thies TDL14 or DL16 Data Logger
- Mechanical Installation
- Operation
- Configuration
- Commands
- General Commands
- help
- ver
- echo
- ps
- date
- log
- attr
- pin
- hwid
- connect
- xfer
- fwupdate
- reboot
- exit
- Data Acquisition Commands
- dacq
- dacq info
- dacq sample
- dacq retrieve
- dacq abort
- dacq date
- dacq interval
- dacq direct
- dacq t
- hist
- hist info
- hist stat
- hist map
- hist purge
- Data Acquisition Legacy Commands
- sdi t
- thi t
- thi direct
- Communication Commands
- net
- net get
- net up
- net down
- net session
- modem
- modem direct
- modem pwrdown
- modem pwrup
- modem reset
- modem mode
- File System Commands
- ls
- mkdir
- cd
- cp
- pwd
- rm
- cat
- Command Line Interface Error Messages
- Attributes
- Technical Specifications
Copyright Notice
Neither the whole nor any part of the information contained in this publication may be reproduced in any
material form except with the prior written permission of the publisher.
All trademarks used throughout this document are the property of their respective owners. Mention of
third-party products is for informational purpose only and constitutes neither an endorsement, nor a
recommendation. Metrilog assumes no responsibility with regard to the performance or use of these
products.
Document rev 2.1, issued 13 May 2022. This document is based on the M717 firmware version 1.04. In
order to improve the performances of the product, Metrilog may issue from time to time firmware
updates. The updates may add, modify or remove certain commands and functionalities, as described in
this document. Metrilog assumes no obligation to update the manual as a consequence.
Metrilog Data Services GmbH, Office Park 4, C38, Vienna Airport City, 1300 Wien-Flughafen, Austria
www.metrilog.com
© 2018-2022 Metrilog Data Services GmbH