User's Guide
Table Of Contents
- Remote Terminal Unit M717
- Table Of Contents
- Introduction
- Installation
- Register the RTU to the M2M Gateway
- The SDI Connector
- The MPI Connector
- The Micro USB Service Connector
- About the Data Acquisition Subsystem
- SDI-12 Sensors
- Create a New Template From an Existing One
- Create a New Template From Scratch
- Interface to a Davis Vantage Pro Console
- Interface to a Thies TDL14 or DL16 Data Logger
- Mechanical Installation
- Operation
- Configuration
- Commands
- General Commands
- help
- ver
- echo
- ps
- date
- log
- attr
- pin
- hwid
- connect
- xfer
- fwupdate
- reboot
- exit
- Data Acquisition Commands
- dacq
- dacq info
- dacq sample
- dacq retrieve
- dacq abort
- dacq date
- dacq interval
- dacq direct
- dacq t
- hist
- hist info
- hist stat
- hist map
- hist purge
- Data Acquisition Legacy Commands
- sdi t
- thi t
- thi direct
- Communication Commands
- net
- net get
- net up
- net down
- net session
- modem
- modem direct
- modem pwrdown
- modem pwrup
- modem reset
- modem mode
- File System Commands
- ls
- mkdir
- cd
- cp
- pwd
- rm
- cat
- Command Line Interface Error Messages
- Attributes
- Technical Specifications
Usage
net get <url> <path>
Remark
Only http und https protocols are currently supported.
Example
: net get https://update.metrilog.com/m717_update_102.pack firmware/
File transfer started, it may take some time...
:
File transfer succeeded, 336108 bytes downloaded
: ls firmware
-rw 336108 Jun 29 2020 17:00 - m717_update_102.pack
Capacity: 0.01 GB (12288 KB), available: 0.01 GB (11600 KB).
4.4.3. net up
Description
Starts up the IP network (connect to the Internet).
Usage
net up
Example
: net up
4.4.4. net down
Description
Shuts down the network connection (disconnect from the Internet).
Usage
net down
Example
: net down
4.4.5. net session
Description
Executes a session with the M2M Gateway.
Usage
net session
Remarks
A complete session is executed; normally the sessions are automatically executed
by the RTU, as speciļ¬ed by the connectSchedule attribute. This command allows
the execution of an outstanding session, or if the connectMode attribute is set to
1, manually.
Example
: net session
4.4.6. modem
Description
Used to show or control the state of the built-in cellular modem.
Usage
modem { direct | pwrup [hard] | pwrdown | reset | mode | -h }
Without a subcommand, the current modem state will be shown. The information
provided may help debug cellular connection problems.
The -h option lists all the subcommands; each subcommand is separately
described in the following sections.
Remarks
Some modem subcommands are not available over telnet.
Example
30