User guide

22 User Guide
Technical Specifications
Data Rate
2711-11
Half duplex _______________________________________________ 10Mbps
Full duplex________________________________________________ 20Mbps
2731-XX
Half duplex ______________________________________________ 100Mbps
Full duplex_______________________________________________ 200Mbps
10Mbps Twisted-Pair Interface (2711-11)
Connector _____________________________________ Shielded RJ-45, 8-pin jack
Impedance___________________________________________ 100 Ohms nominal
Signal Level Output (differential) ______________________________ 2.2 to 2.8V
Signal Level Input ________________________________ .3 to 3.1V p-p minimum
Supported Link Length ____________________________________________ 100m
Cable Type ________________________________________ Category 3 or 5 UTP
(EN55024:1998 compliance) ______________________ Category 5 STP
100Mbps Twisted-Pair Interface (2731-XX)
Connector _____________________________________ Shielded RJ-45, 8-pin jack
Impedance___________________________________________ 100 Ohms nominal
Signal Level Output (differential) _____________________________ .95 to 1.05V
Signal Level Input _____________________________________ 350mV minimum
Supported Link Length ____________________________________________ 100m
Cable Type ____________________________________________ Category 5 UTP
(EN55024:1998 compliance) ______________________ Category 5 STP
100Mbps Multimode Fiber Optic Interface (2731-XX)
Connector ___________________________________________________ ST or SC
RX Input Sensitivity _______________________________ -31 dBm peak minimum
Output Power __________________________ -14 dBm to -23.5 dBm (50/125 µm)
_____________________________ -14 dBm to -20 dBm (62.5/125 µm)
Supported Link Length _______________________________ up to 2km full duplex
Cable Type _____________________________ 50/125, 62.5/125, 100/140 µm F/O