User guide

Metrobility “redundant twister” 7
2
Installation Guide
Follow the simple steps outlined in this section of the guide to install and start
using your Metrobility “redundant twister”.
Unpack the “redundant twister”
Check that the following components have been included:
• “redundant twister” 2711 or 2731
• Two (2) 12V Power Supplies
• Four (4) Rubber Feet
Your order has been provided with the safest possible packaging, but
shipping damage does occasionally occur. Inspect your order carefully for
damage that may have occurred during shipment. If you discover any
shipping damage, notify the carrier and follow their instructions for
damage and claims. Be sure to save the original shipping carton if return or
storage of the unit is necessary.
Choose an Appropriate Location
The “redundant twister” is intended for use in either office or industrial
environments. The converter must be located within six (6) feet of the AC
power source being used and placed as far away as possible from electrical
noise generating equipment such as copiers, electrostatic printers and other
motorized equipment. If exposed twisted-pair wiring is used nearby, the
wiring should be routed as far away as possible from power cords and data
cables to minimize interference.
The units may be oriented in any manner which permits the user to make
physical connection to the power supplies and leaves a minimum of six (6)
inches of space for proper ventilation.
TUV Compliance Note: For pluggable equipment, the socket outlet must be
installed near the equipment and be easily accessible.
Bei Geräten mit Steckanschluß muß die Steckdose nahe dem Gerät
angebracht und leicht zugänglich sein.
1