Access Line Cards Installation & User Guide

12 User Guide
User Guide
This section contains information about the operating features of the
Radiance access line cards.
LED Indicators
The Radiance access line cards provide several LEDs on the front panel for the
visible verification of unit status and proper functionality. These LEDs can help
with troubleshooting and overall network diagnosis and management. There are
separate receive (RX), link (LK), loopback (LBK) and disable (DIS) indicators
for each port.
The following table describes the indication of each LED when lit.
LED LED
Label Name Color (Status) Indication
MAN Managed Green (steady) Unit is receiving management packets.
*
FD Full Duplex Green (steady) Unit is operating at full duplex. When
unlit, the unit is operating at half duplex.
PWR Power Green (steady) Unit is powered ON.
RX Receive Green (blinking) Port is receiving data.
LK Link Green (steady) Port has a valid link.
LBK Loopback Green (steady) Port is in loopback mode.
DIS Disable Green (steady) Port has been disabled by software.
*NOTE: A management card must be installed in the chassis to enable remote management.
Factory Settings
The Radiance access line card provides several user-selectable options to meet
your networking needs. The card’s default settings are listed below.
Default Hardware Switch Settings
MDI-II/MDI-X ..................................................................................Parallel (UP)
The following switches can be overridden through software commands.
*
Link Loss Carry Forward ........................................................ Disabled (DOWN)
Auto-Negotiation ..................................................................... Disabled (DOWN)
Link Loss Return ..................................................................... Disabled (DOWN)
Far End Fault ........................................................................... Disabled (DOWN)
* Refer to the Command Line Interface Reference Guide , NetBeacon Element Management Software Installation &
User Guide or WebBeacon Management Software Installation & User Guide for software management information.