Access Line Cards Installation & User Guide

Radiance Access Line Cards 7
* DIP switches can also be managed via console commands or through Metrobility’s NetBeacon or WebBeacon
management software. Refer to the Command Line Interface Reference Guide , NetBeacon Element Management
Software Installation & User Guide or WebBeacon Management Software Installation & User Guide for software
management information.
DOWN
UP
12345
LLCF
AN1
LLR2
6
FEF2
hctiwS
lebaL
noitisoPnoitcnuF
FCLL
PU.dracehtnodelbanesidrawroFyrraCssoLkniL
NWOD
)tluafed(
.dracehtnodelbasidsidrawroFyrraCssoLkniL
1NA
PU
stiotytilibapacxelpudflah/llufsesitrevdatropreppocehT
syawlasidnadetaitogen-otuatonsideepS.rentrapknil
.spbM001
NWOD
)tluafed(
llufottessitropreppocehT.delbasidsinoitaitogen-otuA
.xelpud
2RLL
PU.tropcitporebifehtnodelbanesinruteRssoLkniL
NWOD
)tluafed(
.tropcitporebifehtnodelbasidsinruteRssoLkniL
2FEF
PU
anodelbanesiFEFfI.delbanesi)FEF(tluaFdnEraF
,knil)XR(eviecerstisesoltroprebifstidnadracetomer
yllacolehtotmraladeticilosnunasdnesdraceht
.dracdeganam
NWOD
)tluafed(
.tropcitporebifehtnodelbasidsitluaFdnEraF
DIP Switches
A bank of six DIP switches is located on the back of the card. Switches
1, 3, 5 and 6 allow you to select from several modes of operation.
These switches are clearly marked on the card’s circuit board. Refer to
the table below for the proper setting of the DIP switches.
*
When setting DIP switches, the UP position is when the lever of the
DIP switch is pushed away from the circuit board. The DOWN position
is when the lever is pushed toward to the board.