Troubleshooting guide

Copyright © 12/13/2002 Travis Industries, Inc.
Old Avalon Pellet Identification
900 Pellet Stove - 1990
Serial # Range 1002 - 1501
900 Pellet Stove - 1991
Serial # Range 2500-2900
900 Pellet Stove - 1992
Serial # Range 2901 - 4299
900 Pellet Stove - 1993
Serial # Range 4300 - 8111
900 PS (Freestanding Pellet Stove) Series
Freestanding pellet stove. Has 3 piece vertical Ceroboard
flat panels in back of firebox. Burnpot and holder are one
welded assembly. Air inlet slider control at lower left side.
Uses two electronic timing blocks located on left side behind
side panel. Switch box at back of stove at upper left.
Freestanding pellet stove. Has brick pattern refractory at
back of firebox. Separate removable burnpot and holder.
Air inlet slider control at lower left side. Enclosed control
box behind left side panel with 2 timing blocks. Wiring
harness uses multiple plug Molex connector to join harness
to control and switch boxes.
Same as 1991 900, except the clip that holds the removable
vertical exhaust ducts (inside the firebox) is welded to the
side of the firebox (not the back).
Freestanding pellet stove. Has brick pattern refractory at
back of firebox. Separate burnpot and holder. Control box
has 5 amp fuse. Wiring harness equipped for ignitor system.
Ignitor option through back of firebox into burnpot holder.
Uses 1, 2, or 3 phase ignitor.
900 Pellet Insert - 1991
Serial # Range 10002 - 10599
900 Pellet Insert - 1992
Serial # Range 11000 - 11491
900 Pellet Insert - 1993
Serial # Range 11501 - 13040
900 PI (Pellet Insert) Series
Pellet insert. Has brick pattern refractory at back of firebox.
Separate removable burnpot and holder. Hopper lid was lift-
off assembly. Serial number label is applied to hopper cover
- you need to remove the top surround panel to see it.
Same as 1991 900, except the clip that holds the removable
vertical exhaust ducts (inside the firebox) is welded to the
side of the firebox (not the back).
Pellet insert. Has brick pattern refractory at back of firebox.
Separate burnpot and holder. Hopper lid is hinged. Serial
number label is applied to hopper cover - remove the top
surround to see it. Control box has 5 amp fuse. Wiring harness
equipped for ignitor system. Ignitor option through back of
firebox into burnpot holder. Uses 1, 2, or 3 phase ignitor.
4