Troubleshooting guide

Copyright © 4/20/2006 Travis Industries, Inc.
YES
NO
Igniter On
• Continuity test igniter
• BAD - Replace
• GOOD - Continuity test pathway
- #1 Pin to BLACK Wire - #7
• Pin to WHITE Wire
• BAD - Replace Wire Harness
• GOOD - Replace Board
NO
• Check for pinched vacuum hose
or blocked hose on flow switch
• (Tube & barbed connector)
• Continuity test auger motor
• BAD - Replace
• GOOD - Check pathway (check
continuity from pin #6 to end of
RED power wire, check Snap
Disk(s) continuity, check Flow
Switch, check pin #7 to the end
of WHITE wire
• BAD - Replace defective item(s)
• GOOD - Replace bBoard
Auger Turning
Move to RUN Mode by
Jumping the System Disk with
a Jumper Wire
YES
2