Troubleshooting guide

Troubleshooting Pellet

Appliances

• Keep the operation sequence in mind.

• Ask what should be working in

• each mode and what should not.

• Before troubleshooting any pellet

• •

•

appliance always UNPLUG and

• re-plug THE APPLIANCE to reset the

• control board, (If the appliance was •

turned off before it finished the cool •

down mode it will start there instead •

of the start-up mode).

• Run through the modes and observe

• what is working or not working.

• Begin with what is not working before you move to the

• next mode.

• Each time the pellet system is turned on it runs a quick self-

• •

•

diagnosis, (you will see the fault light come on and then go off).

• If, during this diagnosis, it senses any problem with the convection

• blower or circuit, the exhaust blower will immediately come on,

• even through the ON/OFF switch is off.

• This automatically tells you there is a convection circuit problem

• that must be corrected.

Troubleshooting

Pellet Appliances

• Mode Sequence

• Ask What?

• Unplug To Reset

• Board

• Move Through

•

Modes of • • • • •

•

Operation

• Self Diagnosis