Troubleshooting guide

Copyright © 4/20/2006 Travis Industries, Inc.
Pellet Stove Continuity
Component Testing
Condition
Good
Continuity Across Wires
(With Vacuum) Continuity
Across Switch Contacts
Continuity Across Wires
Ambient Temperature
No Continuity
Temperature Rise
Continuity
Ambient Temperature
Continuity
Temperature Rise
No Continuity
Ambient Temperature
Continuity
Temperature Rise
No Continuity
Continuity Across Wires
Continuity Across Wires
Condition
Bad - Replace
No Continuity Across Wires
No Continuity Across Switch
Contacts
No Continuity Across Wires
No Continuity With
Temperature Rise
Continuity With Temperature
Rise.
No Continuity When Cold or
When Hot.
Continuity With Temperature
Rise.
No Continuity When Cold or
When Hot.
No Continuity
No Continuity
• Always Have “POWER OFF” When Conducting a
• Continuity Test
• Always Isolate the Component By Disconnecting at
• Least One Side of the Circuit
Component
Auger Motor
Flow Switch
Igniter
System Disk:
Porcelain Snap
Disk F-120˚ F (N. O.)
Safety Hopper
Disk: Snap Disk
L-200˚ F (N. C.)
Convection Chamber
Disk
(Large Appliances)
L-200˚ F (N. C.)
Convection
Blower
Exhaust
Blower
21