Troubleshooting guide

Pellet Wall Thermostat

Thermostat Placement and Installation

1. Determine a location for the thermostat that is within range of the 20' length of

thermostat wire. It should be centralized in the room and away from the heater. The

wire may be routed externally on the wall or behind the wall (preferred). Run the

thermostat wire to this location. Use nylon ties, if necessary to keep the wire from

contacting any hot portions of the heater.

2. Follow the directions below to attach the thermostat and thermostat wires.

50 60 70 80 90

Robertshaw

Run the thermostat wires

through the wall (cut off excess

wire, leaving 6” of slack).

Pull the cover off the thermostat

Expose 1/2” of wire and

attach to these two posts.

Standard

Screwdriver

Attach the thermostat to

the wall through these

two holes.