Troubleshooting guide

Copyright © 4/20/2006 Travis Industries, Inc.
Operating Pellet Sequence
Pellets
Are Burning
and the System
Snap Disk Closes
(Should happen
in 6-7 minutes)
• Igniter Turns Off
• Auger Feed Turns Off
• Exhaust Blower Runs for
• 20 Minutes
YES
START UP MODE
NO
RUN MODE
SHUT DOWN
MODE
FAULT LIGHT ON
• Convection Blower - ON at Control Board Fan Setting
• Exhaust Blower and Auger Feed Rate Mode
• Operating at Control Board Heat Output Setting
HEAT NEEDS ARE SATISFIED
Manual - OFF
Automatic Thermostat - OFF
Remote - OFF
COOL DOWN
MODE
• Convection Blower and Exhaust Blower Run
• • Until System Disk Cools Down and Opens
• Exhaust Blower On High
• Auger Feed On Medium
• Ignitor Heats (Max. 30 Min.)
2