Troubleshooting guide

Copyright © 4/20/2006 Travis Industries, Inc.
Auger Feed Rate Timing
HIGH
MEDIUM
LOW
ON 3 Seconds
OFF 2 Seconds
ON 3 Seconds
OFF 6-9 Seconds
ON 3 Seconds
OFF 12-15 Seconds
• The feed rate of the pellets is determined by the ON/OFF
• cycling of auger motor. Remember the auger motor turns
• at a constant speed of 1 RPM. Therefore, to vary the pellet
• feed, we control the on and off time of the auger motor.
• In the box below you will see the ON/OFF rates:
• The auger feed light on the control board will be lit for the
• following times
HEAT OUTPUT
HEAT OUTPUT
HEAT OUTPUT
3