Troubleshooting guide

Copyright © 4/20/2006 Travis Industries, Inc.
APPLIANCE WILL NOT POWER UP
SYMPTOMS AREA OF FOCUS
OCCURRENCE TIMING
OF PROBLEM
POSSIBLE CAUSE SOLUTIONS
Control Board Does Not Light Up
Operator During Start Up Lack of Operational
Knowledge
Educate
Control Board Does Not Light Up Control Board Does Not Light Up Control Board Does Not Light Up
Selector Switch No 110 v Power Supply Fuses (Main) (Board)
During Start Up During Start Up During Start Up
Selector Switch Not In Proper Position Dead Outlet Blown Fuse
Place In Manual or Automatic Position Repair Dead Outlet Check and replace Main (Rear of Unit) or Board Fuse
Control Board Does Not Light Up
Control Board During Start Up Defective Control Board Replace Board
1