Troubleshooting guide

Copyright © 4/20/2006 Travis Industries, Inc.
PELLETS WILL NOT FEED
SYMPTOMS AREA OF FOCUS
OCCURRENCE TIMING
OF PROBLEM
POSSIBLE CAUSE SOLUTIONS
Pellets Will Not Feed Safety Snap Switches At Start Up Overheated or Defective
Safety Snap Switches
Fix overheating or Replace Defective Snap Disk
Pellets Will Not Feed Pellets Will Not Feed Pellets Will Not Feed
Auger Motor Auger Motor Auger
At Start Up At Start Up At Start Up
Defective Auger Motor Loose or Misaligned Locking Collar Defective Bearing or Dirty Bearing
Replace Motor Properly Locate and Tighten Locking Collar Replace Bearing
3