User guide

6 Devices
IC Net 2.3
188
<Stop> Stop moving the rack to place the specified
vessel at the needle.
Position Selection of the vessel to be placed at the
needle.
Selection: sample, sample+1, spec.#, 1...n
Lift
<Start> Start raising or lowering the lift to the speci-
fied position.
<Stop> Stop raising or lowering the lift to the speci-
fied position.
Position Selection of the position.
Selection: shift, work, rinse, special, 0, 1...125
mm
Pump
<Start> Switch on peristaltic pump at the tower for
the specified time.
<Stop> Switch off peristaltic pump at the tower.
Time Selection of the pump time.
Selection: on (infinite), 1...999 s
Control
<Set> Send specified signal via remote control
lines of the 788 IC Filtration Sample Proc-
essor.
Control lines Selection of special remote line commands
or individual control line settings (details
see 788 Instructions for Use).
Program
<Start> Start program of the Program tab.
<Stop> Stop program of the Program tab.
Sample
<Set> Sample number for manual program start.
Number Selection of the rack position.
Selection: 1...n
For detailed information about the 788 IC Filtration Sample Proc-
essor see 788 Instructions for Use.