User guide

5 Interfaces

IC Net 2.3

Program END, RESET The END flag can be used to end a

program, especially if the program

time should be longer than the

chromatogram duration. Additional

steps after this flag are not allowed.

The RESET flag is used to reset the

parameters to the system startup

values.

Events configuration

On the Events configuration subtab user-defined event commands

can be defined, which can be inserted into a time program after

being activated with <Activate>.

Name (1

column) User-definable name of the event com-

mand (e.g.

Start_766).

Event command (2

column)

Setting the event output lines 1…7.

Selection:

0 (line off, inactive, open)

1 (line on, active, 0 V)

p (pulse, pulse length 150 ms)

* (leave line in current status)

For entry of the first value, enter 1, 0, p or *.

For entry of the other values, move the cur-

sor in front of the value to be changed and

enter

1, 0, p or *.

<Add> Add new remote command.

<Delete> Delete selected remote command.

<Activate> Activate the defined remote commands for

insertion into the time program.