User Manual

Subwindow Curves 271
¯Dos.r.
Dosing rate upper limit exceeded.
_Temp.
Temperature upper limit exceeded.
¯Temp.
Temperature lower limit exceeded.
*
Dosing stopped.
4.11.3 Monitoring report
If the method contains commands of type STAT or DOS, with the context-sensitive
menu item
Monitoring report... in the curve window the dialog window Monitoring
report - 'Command name'
opens for showing information about limit violations for
each monitoring switched-on.
The following columns are displayed:
Time [s]
Time in s until limit violation.
Limit
lower
Lower limit exceeded.
upper
Upper limit exceeded.
ok
Measured value is inside limits again.
[pH] / [U]
Measured value limit.
Meas.v. [pH] / Meas.v. [U]
Measured value at limit violation time.
Volume [mL]
Dosing volume at limit violation time.
Temp. [°C]
Temperature at limit violation time.
Action
The running STAT command was quit, then the determination was stopped.
Stop command (only Titrando)
The running
STAT command was quit, then the next command was started.
Wait for [Continue]
Reagent dosing in the current
STAT command was interrupted until it was
continued by a manual command.
Wait for limit ok
Reagent dosing in the current
STAT command was interrupted until the
monitored measured value was again within the limits (including hystere-
sis). Afterwards reagent dosing was resumed automatically.
[ none ]
No action was taken.