User Manual

Commands 357
Upper limit
-2000.0 ... [ 2000.0 ] mV
(for Window = Measured value)
0.00000 ... [ 9999.99 ] mL
(for Window = Volume)
0 ... [ 999999 ] s
(for Window = Time)
Value for the upper limit of the window.
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
DET Upol
Command for Dynamic Equivalence Point Titrations with amperometric meas-
urement (selectable polarization voltage).
Devices
This command can be executed with the following devices which have the DET
mode:
Titrino: 716, 721, 736, 751, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 855
Appearance
The command has the following appearance:
Parameters
The parameters for the command
DET Upol are configured in the following 7 tabs:
•
General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
•
Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
•
Titration parameters
Parameters for the run of the titration.
•
Stop conditions
Definitions of conditions which cause the stop of the titration.
•
Potentiometric evaluation
Parameters for the potentiometric evaluation of titration curves.
•
Additional evaluations
Definition of additional methods for evaluation of the titrations curves.
•
Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional column in the list of measuring
points.