User Manual

Commands 479
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
MEAS T/Flow
Command for temperature and gas flow measurements.
Devices
This command can only be executed with the 774 Oven Sample Processor.
Appearance
The command has the following appearance:
Parameters
The parameters for the command
MEAS T/Flow are configured on the following 4
tabs:
•
General/Hardware
Parameters for device, sensor and stirrer.
•
Measuring parameters
Parameters for the measurement.
•
Evaluations
Defining further methods for evaluating measurement curves.
•
Additional measured values
Defining further measured values which can be saved as additional
columns in the list of measuring points.
General/Hardware
The general parameters for the control device are defined on this tab.
Command name
25 characters, [ MEAS T/Flow # ]
Name of the command.
Device
Device name
Device name, [ not defined ]
Selection of a 774 Oven Sample Processor from the device table. Addition-
ally,
not defined can be selected. In this case, the device name must be as-
signed by the user at the start of the method.