User Manual

Commands 483
[ automatic ]
If a temperature sensor is connected, the temperature will be measured
continuously. Otherwise the temperature manually entered under
Tempera-
ture
(see Measuring parameters) will be used.
off
The temperature will not be measured. The temperature manually entered
under
Temperature (see Measuring parameters) will be used.
Stirrer
Stirrer
[ 1 ] ... 4, off
Selection of the stirrer.
off means that no stirrer will be used.
Stirring rate
-15 ... [ 8 ] ... 15
Setting the stirrer speed. The direction in which stirring takes place changes
as the sign in front of the stirrer speed changes.
Switch off automatically
[ on ], off
The stirrer is automatically switched off at the end of the command if this
option is activated.
Measuring parameters
Screenshot and parameters: see MEAS U - Measuring parameters
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
MEAS Cond
Command for conductivity measurements.
Devices
This command can only be executed with the 712 Conductometer.
Appearance
The command has the following appearance:
Parameters
The parameters for the command
MEAS Cond are configured on the following 4
tabs:
•
General/Hardware
Parameters for device, sensor and stirrer.
•
Measuring parameters
Parameters for the measurement.
•
Evaluations
Defining further methods for evaluating measurement curves.
•
Additional measured values
Defining further measured values which can be saved as additional
columns in the list of measuring points.