User Manual

Commands 565
Device
Device name
Device name, [ not defined ]
Selection of a device from the device table. Only those devices being able
to execute the command are selectable. Additionally,
not defined can be se-
lected. In this case, the device name must be assigned by the user at the
start of the method.
Device type
Device types, [ Titrando ]
Display or selection of the device type. If a device is selected under
Device
name
, this parameter is not editable any more. The device type belonging to
the selected device is displayed instead.
If the option
not defined is selected as Device name, all device types being
able to execute the command can be selected independently from the de-
vices in the device table.
Remote box
[ 1 ] ... 4
(only Titrando, 814, 815, 855)
Selection of the remote box at which the lines are to be scanned.
Scan lines
Input signal
Binary pattern of exactly 8 characters (0, 1,*), [ ******** ], signal template
Input of the binary pattern for the expected input signal or selecting a pre-
defined Signal pattern.
The following characters can be entered:
0
= Line inactive
1
= Line active
*
= Any line condition
The bits are always numbered from right to left:
Input 7 6 5 4 3 2 1 0
Bit 7 6 5 4 3 2 1 0
Example:
*******1 is waiting for an active input on line 0 (1 = set). For
example, this line is set by a Titrino after a titration has been completed and
the Titrino can accept a start signal again.
Note
Input lines that are of no interest or for which no defined condition can be pre-
dicted should also be masked with an asterisk ( * ).
Timeout
on, [ off ]
Maximum waiting time for the input signal.