User Manual

768 How to proceed
7.3.2 Start determination series
Determination series without statistics
1. Select program part Workplace.
2. In subwindow
Run, click on tab Determination series.
3. If desired, enter Determination parameters.
4. Load existing sample table or enter sample data directly into the working sample
table.
The subwindow
Method shows the method loaded in the first line.
5. If a method was loaded in which the option
Statistics in the START command is
enabled, disable the checkbox
Statistics on the tab Determination series.
6. Click on
[Start].
The first determination of a sample series will be started. The subwindow
Method
shows active tracks and commands, the subwindow Live display live curves,
measured values and messages.
Determination series with statistics
1. Select program part Workplace.
2. In subwindow
Run, click on tab Determination series.
3. If desired, enter Determination parameters.
4. Load existing sample table or enter sample data directly into the working sample
table.
The subwindow
Method shows the method loaded in the first line.
Note
In order to calculate statistical calculations for results, the option Statistics must
be enabled in the START command of the method and, additionally, the option
Statistics must be enabled in the CALC command of each desired result.
5. Enable the checkbox Statistics on the tab Determination series and modify the
number of single determinations if desired.
6. Click on
[Start].
The first determination of a sample series will be started. The subwindow
Method
shows active tracks and commands, the subwindow Live display live curves,
measured values and messages.
Note
If the method contains a DATABASE command, this command must be executed
in all statistically linked determinations. Otherwise the statistical results will be
displayed faulty and the determinations cannot be reprocessed.