User's Manual

SCALE PROGRAM MODE

7. If the system is equipped with a remote scale display, it will read H - - -.

8. Use the vertical window to scan the desired scale configuration bar

codes, located on pages 5 - 19.

Figure 5.

9. Reconnect the scale-to-host RS232 cable to the scanner (dual cable

interface only.)

Figure 6.

10. The scale must now be calibrated, tested and certified by local Weights

and Measures authorities before it can be placed in service.

For further details on calibration procedures for Weights and Measures

certification, refer to the Scale Operation: Calibration section of the Stratos

Installation and User’s Guide.

The certification of the weighing mechanism of the scale version of

this scanner is subject to federal, state and local Weights and

Measures statutes and regulations and can only be performed by

authorized government agencies and/or their duly registered agents.

Each time the scale or weighing mechanism is calibrated, it should

be properly sealed with a paper seal or a wire seal prior to being

placed into service in commerce.

It is the responsibility of the owner of the scale to confirm compliance

with the relevant Weights and Measures statutes and regulations

applicable in your area by checking with the appropriate government

agency before placing a newly calibrated unit into service or

removing any official seals.

Type of seal to be used will depend on the guidelines specified by

the local Weights and Measures authorities.