laser bar Installation and User's Guide MS7600 HorizonTM

Figure 18: RS232 or Light Pen

Interface

INSTALLATION FOR RS232 OR LIGHT PEN INTERFACES

1. Turn off the host system.

2. Connect the PowerLink cable into

the 1

jack down from the top of the

MS7600.

3. Connect the other end of the

PowerLink cable to the host.

Before continuing verify that the

PowerLink cable is connected to the

appropriate interface jack on the

scanner. An incorrect cable

connection can cause

communication problems or potential

damage to the scanner.

4. Connect the external power supply

to the power jack on the Power Link

Cable.

5. Check the AC input requirements of

the power supply to make sure the

voltage matches the AC outlet.

6. Connect AC power to the

transformer. The outlet should be

near the equipment and easily

accessible.

7. Scan the appropriate bar codes

on page 14 to configure the MS7600

for RS-232 or Light Pen

communication.

8. Turn on the host system.

Caution:

To maintain compliance with applicable standards, all circuits connected to the scanner must meet the

requirements for SELV (Safety Extra Low Voltage) according to EN 60950.

To maintain compliance with standard CSA C22.2 No. 60950-00/UL 60950 and norm EN 60950, the power

source should meet applicable performance requirements for a limited power source.