User`s guide

5
Disconnecting PowerLink Cables from the Scanner
Before removing the cable from the scanner, Metrologic recommends
that the power on the host system is off and the power supply has been
disconnected from the PowerLink cable.
1. Locate the small ‘pin-hole’ on the top of the unit near the bottom of
the Voyager logo.
2. Bend an ordinary paperclip into the shape shown above.
3. Insert the paperclip (or other small metallic pin) into the small ‘pin-
hole’.
4. You will here a faint ‘click’. Pull gently on the strain-relief of the
PowerLink cable and it will slide out of the scanner.
1
2