User`s guide

Chapter
5
BASIC
Commands
113
5.18.5 Programming RF Base - RS-232 Host Command Sets
Automatically Update Status: @AT RF Base
Purpose
To update information of bases and terminals automatically.
Note that there will be no return of @BSbbgc if only one base exists.
Syntax
@AT\r
Return
@BSbbgc…\r (bbgc may repeat)
bb: Base ID (01 ~ 16)
g: Group number (1 ~ 3)
c: Channel number (1 ~ 4)
@TMbbtt…\r (tt may repeat)
bb: Base ID (01 ~ 16)
tt: Terminal ID (01 ~ 45)
Broadcast Data: @BC RF Base
Purpose
To broadcast data to all registered bases.
Note that all bases are connected via RS-485 as a daisy chain; therefore, data may
not be sent to all registered bases if any of them fails.
Syntax
@BC…ddd…\r
Return
None
List Base Station @BS RF Base
Purpose
To get information of bases, such as their groups and channels.
Syntax
@BS\r
Return
@BSbbgc…\r (bbgc may repeat)
bb: Base ID (01 ~ 16)
g: Group number (1 ~ 3)
c: Channel number (1 ~ 4)