Instruction manual

Advanced Settings
28
Setting Item Default Value Setting Details
Back 80Hz(THX) Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
r
In any of the following cases, this setting will be
set to "None".
– "Surround" is set to "None".
– "Speaker Settings" - "Front Speakers Type" is
set to "Normal“ or "Passive Subwoofer" is set
to "Yes", "Powered Zone 2" is set to "Yes" and
ZONE2 is set to on.
– "Speaker Settings" - "Powered Zone 3" is set
to "Yes", and ZONE 2 and ZONE 3 are set to
on.
r
"Full Band" can be selected only when
"Surround" is set to "Full Band".
Back ch 2ch Select the number of channels of the connected
surround back speaker.
"1ch": When one speaker is connected (Connect to
the BACK L terminal)
"2ch": When two speakers are connected
r
The setting cannot be changed if "Back" is set to
"None".
Wide None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
"None": When no compatible speaker is connected
r
In any of the following cases, this setting will be
set to "None".
– "Surround" is set to "None".
– "Speaker Settings" - "Front Speakers Type" is
set to "Bi-Amp".
– "Speaker Settings" - "Height 2 Speakers
Type" is set to other than "Not Use".
– "Speaker Settings" - "Powered Zone 2" is set
to "Yes".
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
Setting Item Default Value Setting Details
Height 1 None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
r
The setting is fixed to "None" if "Height 1
Speakers Type" is set to "Not Use".
r
The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
AMP".
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
r
If any type is selected in "Speaker Settings" -
"Height 1 Speakers Type", this setting will be set
to "80Hz(THX)" as default value. In this case, this
setting cannot be set to "None".
Height 2 None Select the crossover frequency from "40Hz" to
"200Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
r
The setting is fixed to "None" if "Height 2
Speakers Type" is set to "Not Use".
r
The setting cannot be changed if "Speaker
Settings" - "Front Speakers Type" is set to "Bi-
AMP".
r
"Full Band" can be selected only when "Front" is
set to "Full Band".
r
If any type is selected in "Speaker Settings" -
"Height 2 Speakers Type", this setting will be set
to "80Hz(THX)" as default value. In this case, this
setting cannot be set to "None".
LPF of LFE 120Hz Set the low-pass filter for LFE (low-frequency effect)
signals in order to pass lower frequency signals than
the set value and thus cancel unwanted noises. The
low-pass filter will be effective only on sources with
LFE channel.
Select a value between "80Hz" to "120Hz".
"Off": Do not use this function