Installation & Assembly
INSTALLATION INSTRUCTIONS FOR N6465-652
W
ARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.2)
1. Shut off the power at the circuit breaker and remove the
old fixture from ceiling, including the old crossbar.
2. Carefully unpack the new fixture and lay all the parts on a
clear surface.
3. Attach the loop (I) to the
fixture body (K)
by turning it
clockwise until tight.
HANGING THE FIXTURE (Fig.1)
4. Thread the nipple (C) into the loop (F) until snug.
5. Thread the other end of the nipple (C) with the loop
attached into the crossbar (D) until snug.
6. Place lock washer (B) over end of nipple protruding through
crossbar and thread hex nut (A) onto nipple until tight.
7. Take this crossbar assembly and mount to ceiling junction
box with junction box screws (E) (Size: #8-32*1/2"L). The
side of the crossbar marked "GND" must face out. Tighten
screws securely with screwdriver.
8. Using proper chain pliers to open one end link of the chain
provided and connect to the fixture loop (I); then close the
link.
9. By measuring, determine correct number of links needed
for proper hanging height. Using proper chain pliers
disconnect and discard remaining chain.
10. Lace the fixture wires through the chain.
11. Slip loop collar (H) and the canopy (G) over the chain.
12. Open the other end link of the chain and hang the fixture on
the loop at the ceiling. Close the link.
13. Feed the fixture wires through the loop (F) and nipple (C)
and pull until tight.
CONNECTING THE WIRES (Fig.3)
14. Connect the electrical wire as shown in figure 3, making
sure that all wire connectors are secured. If your outlet has
a ground wire (green or bare copper), connect the fixtures
ground wire to it. If the junction box has no ground wire,
attach the bare copper fixture wire to the green ground
screw (Screw: #8-32*3/8”L) on the crossbar. Tuck the wire
connections neatly into the ceiling junction box.
COMPLETING THE INSTALLATION (Fig.2)
15. Raise the canopy (G) all the way to the ceiling; then raise
the loop collar (H) and thread into ceiling loop protruding
through canopy.
16. Thread the pipe nipple (L) into bottom center of the fixture
body (K) by turning it clockwise until tight. Attach the column
(M), the ring (N) and the frame (O) to bottom of the fixture body
(K), aligning the hole with pipe nipple and screw it with ball nut
(P).
17. Place the candle sleeve (J) and the glass cup (U) over the
socket.
18. Install the light bulbs (not included) in accordance with the
fixture’s specifications: DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
19. Hang the crystals (T) and the crystals (S) to the loop of the
fixture body (K)
.
20. Hang the crystals (R) to the loop of the
frame (O)
.
21. Hang the crystal (Q) to the loop of the
ball nut (P)
.
Your installation is now complete. Return power to the junction
box and test the fixture.
Fig.1
Fig.2
CHAIN HUNG FIXTURE INSTRUCTION
Notice: It is important to use proper chain pliers (not
included) To OPEN and CLOSE the chain included with
this fixture. Do not open them with other tools that may
twist or stress the chain links. It is important to use proper
chain pliers like the ones shown in the diagram.
Fig.3