Installation Sheet

INSTALLATION INSTRUCTIONS
Item #N7304-598 (04/2 0 /2015)
READ AND SAVE THESE INSTRUCTIONS
WAR N I N G ! S H U T P OW E R O F F AT F U S E O R C I R C U I T B R E AK E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING THE FIXTURE (Fig.2)
1. Shut off the power at the fuse box or circuit
breaker. If necessary, remove the existing fixture
and its mounting hardware from the ceiling.
2. Carefully remove the new fixture from the carton
and check that all parts are included as shown in
the illustration.
MOUNTING THE FIXTURE (Fig. 1)
3. Thread the two fixture screws into the mounting
strap spaced the same distance apart as the
holes in the canopy.
4. Attach the mounting strap to the outlet box using
the box screws (Size: #8-32*0.5L). The side of
the mounting strap marked “GND” must face
out.
CONNECTING THE WIRES (Fig. 3)
5. At this point, connect the electrical wires as
shown in Fig. 3, making sure that all wire
connectors are secured. If your outlet box has a
ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the mounting
strap using the green screw provided. After the
wires are connected, tuck them carefully inside
the outlet box.
6. Place supporting cable through lock and secure
with screw, Place the supporting cable through
mounting strap and lock and secure with
screw.(if the fixture provide supporting cable)
FINISHING THE INSTALLATION (Fig. 1 and 2)
7. Place the fixture canopy over the two fixture
screws and secure with decorative nuts.
8. Install the light bulb (s) in accordance with the
fixture’s specifications. (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS
DEPASSER LA PUISSANCE NOMINALE
MAXIMALE!) NOTE: BULBS WILL BE HOT!!
ALLOW SUFFICIENT TIME FOR BULBS TO
COOL BEFORE HANDLING.
Your installation is now complete. Return power to
the outlet box and test the fixture.
Note: Illustration on this manual is for
installation purposes only. It may or may not
be identical to the fixture purchased.
Fig.1
Fig.2
Fig.3
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Set A-012
-Mounting plate
-Ground screw
-Mounting screws (2)
Outlet Box
Mounting Strap
Supporting Cable
Lock
Screw