Instructions / Assembly

INSTALLATION INSTRUCTIONS
Item#N7534-726-L (New. 2022/12/06)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEU
Fig. 2
Fig. 1
LA-3243E
PREPARATION (Fig.1)
1. Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clean area. Take car
e not to misplace any small parts
necessary for installation.
3. Determine desired hanging height and thread rods (F1, F2
and F3) to all thread (G) on fixture body. Attach canopy (D)
by threading on to rod (F1). Carefully pass wires through
each rod during assembly.
4. Attach mounting plate (A) to junction box (not included)
with mounting screws (B) (Size: #8-32N*L0.5”). The side
of mounting plate (A) marked “GND”
and two convex
points must face out.
5. The
support cable is provided to support weight of fixture
while wiring. Align fixture to mounting plate (A
) and attach
hook (T) on the end of support cable (C
) into a slot located
on mounting plate (A). Carefully allow support cable (C
) to
support the weight of fixture while wiring (Fig.1).
CONNECTING THE WIRES (Fig. 2)
6. Connect the electrical wires as shown in Fig. 2, making
sure that all wire connectors are secured. If your junction
box has a ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect fixture’s
ground wire direc
tly to mounting plate (A) using green
screw provided.
7. Tuck wire connectors neatly into the junction box
COMPLETING THE INSTALLATION (Fig. 1)
8. Place canopy (D) over mounting plate (A) and secure with
screws (E).
9. Secure all thread (L) (with nut side) onto metal washer (J),
plastic washer (I) and glass shade (H), then secure them
onto coupling (P). (Notice: Please don't secure
too tight to
prevent glass from breaking)
10. Place glass shield (M), plastic washer (I) into all thread (L)
and secure with finial (N).
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
H
OUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Page:1/2
Set#A-021-118DH
-Mounting plate
-Ground screw
-Mounting screw *2
Rod# W30-1-695 *1 (F1)
W30-1-695 *2 (F2)
W30-H-695 *1 (F3)
F2
F3
F1
T
G
P
H
K
L
M
N
I
I
J
A
C
B
D
E