Manualshelf

Instructions / Assembly

ManualsBrandsMetropolitan ManualsLightingPresten 4-Light Brushed Nickel and Sand Coal Drum Pendant
12
Page:1/2
ASSEMBLY THE FIXTURE (FIG.1&FIG.3)
1.
Shut of power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2.
Carefully unpack your new fixture and lay out all the parts in
a clean area. Take care not to
misplace any small parts
necessary for installation.
3. Determine the desired height and thread rods (G1
and G2)
together.
Screw loop (I1) to the rod (G1). Pass the wires
carefully through each rod as you assemble.
4. Attach the quick link (H) to the loop (I2
) on the canopy (D).
Carefully feed the wire through loop (I1), quick link (H) and
loop (I2). Assemble the bottom end of rod
into the coupling
(J).
5. Attach the circular strap (B) to the junction
junction box screws (C). The side of the circular strap
(B)
marked “GND” must face out.
Mounting screw can be
adjustable if necessary.
6.
The support cable is provided to support the weight of the
fixture while wiring. Raise the fixture to circular strap (B
) and
attach hook on the end of support cable (E) into a
slot
located on circular strap (B
). Carefully allow the support
cable (E) to support the weight of the fixture while wiring.
CONNECTING THE WIRES (FIG. 2)
7. C
onnect the electrical wires as shown in figure 2, making sure
that all wire connectors are secured. If your junction
has a
ground wire (green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s ground wire
directly to the circular strap (B)
using the green screw
provided.
8. Tuck the wire connectors neatly into the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
9. Raise the fixture over the mounting screws (A
) and secure
with decorative nuts (F).
10. Place the candle covers (K) over the sockets (L).
11. Install (4) four candelabra base bulbs (M) up to 60 watts e
ach
or CFL or LED equivalent (not included) in accordance with
the fixture specification—
DO NOT EXCEED THE MAXIMUM
WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!).
Your installation is now complete. Turn on the power supply of the
junction box to test the fixture.
Note: Illustration (Fig. 1) on this manual is for installation
purposes only. It may or may not be identical to the fixture
purchased.
Fig.1
INSTALLATION INSTRUCTION FOR FIXTURE #N7984-420
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Set A#A-020
-Circular Strap
-Ground Screw
-Mounting screws (2)
Rod#W30-1-84*3(G2)
Rod#W30-H-84*1(G1)
Candle cover# CCV21060P-84

Summary of content (2 pages)