User's Manual

WESROC© RMS Satellite Repeater – User Manual
Metrotel Corporation of Minnesota, Inc.
Revision A. May 7, 2008 Page 7
Wesroc® Portable Diagnostic Unit Field Control Module
In order to configure a Satellite Repeater in the field, the installer must have a
Wesroc® Portable Diagnostic Unit (PN: MT9100-PDU). The portable diagnostic
unit is for receiving and displaying status and configuration information
transmitted by the Satellite Repeater (along with any other Wesroc® RMS
devices that are present). The PDU also transmits configuration information to
the Satellite Repeater. To power up the PDU, press the PWR button. The logo
screen will then be displayed.
Logo Screen
To view Wesroc® RMS transmitters, press the right button from the logo screen.
When power is applied to the Satellite Repeater it will transmit status information.
The transmitter list screen shows which transmitters have been heard from. The
Serial Number of the device, the type of device, the Time Since Last
Transmission and the Received Signal Strength are shown. The transmitter
screen will look something like this:
Transmitter List Screen
To look at the detailed information that is sent from the Satellite Repeater, push
the up and down arrows until the selection arrow is pointed at the entry for the
Satellite Repeater. Then press the right button.