User Manual

WESROC

RMS

Base Unit & Transmitter Installation Guide

TRANSMITTER INSTALLATION

The Transmitter has five basic operating modes.

The following table defines the operating modes and programming magnet positions for each of the

modes.

NOTE: To maximize battery life, set the Transmitter to OFF mode when not in use.

Operating Mode OFF Position INIT Position

OFF X

INITIALIZATION X

TRANSMITTER NUMBER X X

PARAMETER * X

NORMAL

* Must be entered from Transmitter Number mode.

Program Transmitter Number

• Transmitters are set to transmitter number 1 by default. To change the Transmitter’s number for a

multi-tank installation, perform the following steps:

o Place the transmitter into TRANSMITTER NUMBER Mode

- Place one programming magnet in the OFF position.

- Place another programming magnet in the INIT position.

o If a Transmitter Monitor is being used to monitor transmissions, the transmitter number and

serial number will automatically be displayed. If a Base Unit is being used to monitor

transmissions, the Base Unit must first be placed into “4 PG” PROGRAM Mode.

- Enter the Installation Menu (refer to the Base Unit Installation section for details).

- Use the UP/DOWN arrows to display “4 PG” and press MODE to enter PROGRAM Mode.

This mode is indicated by a flashing “P”.

- Only a transmitter with a changing transmitter number will be displayed. The number to the

left of the flashing “P” is the transmitter number, and the two numbers to the right are the

last two digits of the transmitter’s serial number.

- When done, press and hold MODE to return the Base Unit to Tank Level Display Mode.

o Wait for the transmitter

number of the Transmitter to change to the desired number (1 - 8).

o Once the desired transmitter

number has been received, immediately remove the

programming magnet from the INIT position.

NOTE 1: The displayed transmitter number will change approximately every 5 to 6 seconds

while the transmitter is in TRANSMITTER NUMBER Mode.

NOTE 2: Transmitter number programming can be performed in the field or at your office prior

to installation. Transmitters programmed to a number other than “1” should be

marked to reflect the new transmitter number.

Figure 3:

WESROC

RMS

Transmitter