Manualshelf

User Manual

ManualsBrandsMetroTel Corp of Minnesota ManualsElectronicsFuel Tank Level Transmitter
12345678910
WESROC
®
RMS
Base Unit & Transmitter Installation Guide
72-70-125-ITC Rev. A © Copyright 2007, Independent Technologies, Inc. Page 9
TRANSMITTER INSTALLATION (continued)
Replace Gauge Dial
• Record the current tank level on the old dial in a notebook or in the space provided in this guide.
• If the tank gauge is not already equipped with a sensor ready dial, replace the dial with one having
a sensor interface (Rochester R3D). Tanks with older Taylor 4-bolt gauges may need a dial
adapter to enable upgrading to a sensor ready dial.
• Record the current tank level on the new dial in a notebook or in the space provided in this guide.
WARNING!!!
DO NOT REMOVE THE SCREWS HOLDING THE TANK GAUGE HEAD IN PLACE!!!
TANK DECOMPRESSION CAN CAUSE SERIOUS INJURY AND/OR PROPERTY DAMAGE!!!
Install Transmitter
• Place the Transmitter on the tank near the gauge; the mounting magnet will hold it in place.
• Carefully route the sensor cable to the dial and position the cable so that it will not be damaged
when the tank hood is closed.
• Snap the sensor on the end of the cable into the face of the sensor ready dial.
• Secure the sensor cable to the tank using at least one of the supplied cable ties.
• Re-position the Transmitter on the tank to take up any excess cable slack.
• TO ENSURE SAFE OPERATION:
o The Transmitter MUST be installed according to the instructions in this guide.
o DO NOT connect the Transmitter to any apparatus or wiring from another manufacturer.
o DO NOT open the Transmitter enclosure under any circumstances. The Transmitter has no
field serviceable parts and the internal batteries ARE NOT user replaceable.
NOTE 1: MT-9100TNK-U Universal Transmitter sensor cables are attached to WESROC RMS
Large Dial assembly cables using in-line connectors. Carefully connect the two cable
sections, making sure the locking ring on the connector is fully engaged. This will
ensure that the connector remains weatherproof.
NOTE 2: If a Transmitter is removed or taken out of service, place a programming magnet in
the OFF position and tape into place. This will maximize the battery life of the unit.