User's Manual

WESROC
®
RMS Industrial CTM - Operation Manual - Independent Technologies, Inc.
72-70-209, Rev. A Page 14 01/18/2017
Portable Diagnostic Unit
General
The handheld WESROC
®
RMS Portable Diagnostic Unit (PDU) is used to configure and
monitor the status of the WESROC
®
RMS Industrial LTE Cellular Tank Monitor (CTM).
This valuable device should be considered an essential part of any installation tool kit. The
following is a summary of the sections of the PDU interface that are designed for use with
the CTM. A more detailed description of the operation of the PDU can be found in the
WESROC
®
RMS Portable Diagnostic Unit Operation Manual.
A configuration data packet is required to be transmitted by the CTM before the PDU can
be used to configure the CTM or view detailed data from the CTM. The CTM will transmit a
configuration data packet before and after each report to the Host, when the CTM is
placed in Configuration mode, and each time a configuration command is received from
the PDU. The CTM must be in Configuration mode to respond to configuration commands
sent by the PDU. A configuration command is sent from the PDU to the CTM each time the
user changes a configuration parameter value and leaves a configuration parameter
editing screen.
PDU Screen Map
Logo
Screen
Device
List
Screen
Main
Menu
Screen
Summary
Screen
Config
System
Screen
Config
Application
Screen
Details
Screens
Command
List
Screen
Parameter
Edit
Screens
Parameter
Edit
Screens
Raw Data
Screens
Command
Execution
Screens