Operating instructions

"7/MARK" 7 data bits/mark parity
"7/SPACE" 7 data bits/space parity
"7/EVEN" 7 data bits/even parity
"7/ODD" 7 data bits/odd parity
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
"STOPBIT" – Stop Bits RS232C
1)
At this menu topic you can set the stop bits of the transmitted data to different RS232C serial receivers.
"1 BIT" 1 Stop bit (Factory setting)
"2 BITS" 2 Stop bits
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
"HD.SHAKE" – Handshake RS232C
1)
This menu topic allows you to match the data transmission to different RS232C serial receivers.
"XON/XOFF" Software handshake (XON/XOFF) (Factory setting)
"RTS/CTS" Hardware handshake (RTS/CTS)
"OFF" No handshake
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
"RS E.O.L." – End of Line RS232C
1)
At this menu topic you can set the "End of Line" character of the transmitted data to different RS232C serial
receivers.
"(CR)(LF)" <CR><LF> Carriage Return followed by Line feed (ASCII-Codes
013+010) (Factory setting)
"(CR)" <CR> Carriage Return (ASCII-Code 013)
"(LF)" <LF> Line feed (ASCII-Code 010)
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
"RS CHAR" – Char Set RS232C
1)
At this menu topic you can set the "Character Set" of the transmitted data to different RS232C serial receivers.
"IBM/DOS" Char Set IBM/DOS (Factory setting)
"ANSI/WIN" Char Set ANSI/WINDOWS
Note:
●
Not visible for 2nd display.
●
Each device has separate settings.
39The Menu