Operating instructions
"USB" – USB Interface
At this menu topic you can select the mode of the "USB Device" interface and specify how the data is transmit
ted.
"USB" Select the mode of the "USB Device" interface
"SEND.OFF" Send mode switched off (Factory setting)
"SEND.STB" If the « » key is pressed, the next stable weight value will be
sent.
"SEND.CONT" All weight value updates will be sent regardless of stability, with
out pressing the « » key.
"SEND.AUTO" Every stable weight value will be sent, without pressing the « »
key.
"SEND.ALL" If the « » key is pressed, the weight value will be sent regard
less of stability.
Note: This port is not usable for printers or displays.
Note: This menu topic is not available with MSxxxKLIPE models.
"USB COM.S." – Options for the Data Communication Format (USB)
This menu topic allows you to set the data format depending on which peripheral device is connected.
"MT-SICS" The MT-SICS data transfer formats is used. (Factory setting)
For more information see section “MT-SICS Interface Commands
and Functions”.
The following PM balance commands are supported:"MT-PM"
S Send value
SI Send immediate value
SIR Send immediate value and repeat
SR Send value and repeat
SNR Send next value and repeat
T Tare
TI Tare immediately
B Base (Negative values are limited up to the current tare
values)
MI Modify ambient vibration
MZ Modify Auto Zero
M Modified settings reset
ID Identify
CA Calibrate
D Display (only symbol N and G available)
The following Sartorius commands are supported:"SART"
K Ambient conditions: very stable
L Ambient conditions: stable
M Ambient conditions: unstable
N Ambient conditions: very unstable
O Block keys
P Print key (print, auto print; activate or block)
Q Acoustic signal
R Unblock keys
S Restart/self-test
40 The Menu