Operating instructions

The “Percent Weighing” application
105
9.3.3 Special Information Fields for Percent Weighing
On the first page of the menu for info fields the following settings for percent weighing
are available:
“Reference%: Reference value percent.
“Reference”: Absolute weight value of the reference.
“Target value”: Displays the target which was input with this key.
“+Tol” and “–Tol”: These information fields display the tolerances which were
input with this key.
All other information fields are the same as for the “Weighing” application (section
5.2.4).
Factory setting: “Reference%” and “Reference” activated.
9.3.5 Special Information for Percent Weighing
In the three submenus where you can specify the options for the header line of the report,
for reporting the individual values, and for the footer line, you also have additional settings
available for percent weighing which are described below.
Note: All other information items in the report are the same as in the “Weighing” applica-
tion (section 5.2.8) and are not described here.
9.3.4 Additional Unit for Percent Weighing
In the menu for the “Display Unit” and the “Info Unit”, in addition to the known weighing
units the unit “%” (percent) is available (provided that a reference has already been
determined).
Note: For percent weighing you do not need to explicitly select the “%” unit, since the
display unit is always switched over to “%” automatically when the reference is determined.
Afterwards, you can select the desired unit again whenever you want to.
Factory setting: “g” (gram) for “display unit” and for “info unit”.